Enhanced scenes

[ChrisDixon]

Hi
I have created an enhanced scene (full overload mode) of a product.
I used this scene to create a drafting view on a drawing.
Since i created the scene I have added another part to the p
When I go into the scene this new part does not appear on the spec tree.
I would like this new part in the scene ,so the drawing view will update with it in.
I am using R14 SP04 on W2K.
I could create a new scene with it in , but then the drawing view will not update.
Any ideas ??

thanks

Chris

 

[forfun]

Hi

I found that "Partial Overload Mode" updates easier than "Full". While in the scene have you tried the icon "Apply Assembly on Scene"?

hope this helps
forfun

 

[lordrailie]

I just had the same problem, and tried the apply assembly on scene with no succes...

 

[forfun]

"Overload Mode Full
When you create a Enhanced Scene in Overload Mode Full, all attributes are immediately considered overloaded.
All subsequent modifications to the Assembly will have no impact on the Enhanced Scene and vice-versa."

This was taken directly from catia documentaion.

 

[ChrisDixon]

Thanks forfun , I must have mis-read the documentation.