Equations in SW

[RBasniak]

Hi people...

I just wanna know if it's possible to add some coments in equations in SW... the names that he puts in the equations turns the equations too confuse! :-(

Bye,
Rodrigo Basniak
Curitiba, PR
Brazil

 

[ffrreedd]

Try this:
"D1@Sketch1" = "D2@Sketch1" 'comment

 

[BBJT]

Yes it is possible.

Here is an example that I copied from the help file in SolidWorks.

Type a single quote (‘) at the end of the equation, then enter the comment. Anything after the single quote is ignored when the equation is evaluated.

For example: "D2@Sketch1" = "D1@Sketch1" / 2 ‘height is 1/2 width

BBJT CSWP

 

[RBasniak]

Thank you so much... that was exactly what I need!