Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
ERMAKSAN POWER BEND FALCON
- Thread starter cn5
- Start date
btrueblood
Mechanical
Have you called the manufacturer or his representative?
I do not know this machine , but on a large number of CNC press brakes when the machine is first turned on the X and Y axis have to calibrated. See if you can find and enable the calibration modes on the machine. Sometimes if the machine has been newly installed one of the rams may have dropped in shipping requiring it to be jacked into position before the machine will enable. When all else fails call the manufacturer.
B.E.
You are judged not by what you know, but by what you can do.
B.E.
You are judged not by what you know, but by what you can do.
- Status
Similar threads
- Locked
- Question