Error: Failed to find baud and parity

[anass DRT]

hello
plz i need your help as soon as possible.
i can't connect to slc5/04 i have always this message"failed to find baud and parity.."
i use cable USB-174-CP33
i don't have this program offline.
i change error to CRC , i change full to half duplex no thing happen .
plz help .!!

 

[IRstuff]

Did you actually change the baud rate?

TTFN (ta ta for now)
I can do absolutely anything. I'm an expert!

https://www.youtube.com/watch?v=BKorP55Aqvg

faq731-376 forum1529 Entire Forum list

http://www.eng-tips.com/forumlist.cfm

 

[John2025]

Is it a new cable? Flipping the transmit and receive wires is a possibility.

 

[jcaden]

Look at computer-properties-hardware-device manager. Look for Ports. Your USB port should show up. Click on it and check if the "Device is Working Properly". Check the baud rate,parity, etc settings, as well as the Com port number. Match them with the RS-Linx settings.