Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

error, working revisions limit exceeded

Status
Not open for further replies.

dtharrett

Mechanical
Feb 28, 2008
137
0
0
US
In the last few days, two different users on two different assemblies received the attached error. We are running NX 8.0 with TC integration. The error seemed odd as we are at rev NX003. Any thoughts as to what the problem or fix could be?
 
Replies continue below

Recommended for you

Shooting blindly, but clean your TC local cache folder.


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli
 
Status
Not open for further replies.
Back
Top