ETABS Linear Support

[Redtelis]

Hi,

Is there any way to assign a linear support on ETABS? I remember doing it easily on TEKLA & ROBOT but I can't find how to do it on ETABS.

Ideally I would like to achieve a support like is shown within the attached file.

 

[Trenno]

You could define a very stiff (1E+11) line spring. Pretty much the same thing.

 

[estructe]

Would you like to model three elements framing into a single joint? That's easy to do.

Structural Analysis of 2D Structures software
Static, Dynamic,Linear and Non-Linear Analysis
of frames, trusses, beams etc.