ETAP and synchronization check.

[beyond86]

Hi! Need yours help with ETAP and check synchronization.
I'm trying to make condition when two independent systems unite by closing intertie CB. So I need to set some angel between two systems and then check synchronization with some parameters. How I can to setup angle between voltage in ETAP?
Thanks!

 

[Wfg42438]

Can you please confirm what type of study you are running ?

 

[mparenteau]

Could be wrong...I don't think any study software can do that. Standard sync check relays use +/-10 degrees.

Mike

 

[beyond86]

Transient stability.