Eurotherm 590 Fault

[grommit9999]

hello problem magnets

I have a Eurotherm 590 drive which when the run command is active the drive LCD display goes blank and there is no output to the motor.
Has anyone come across this problem ?
If so can you advise

thanx in advance

grommit

 

[Skogsgurra]

You have tried the obvious tests?

Gunnar Englund

http://www.gke.org

 

[grommit9999]

hi skogsgurra

i am flying out to see this drive in a couple of days
the people who maintain the equipment dont have any experience of this type.
I will carry out the obvious when i get there but i posted just in case this fault had raised its head before to give me a heads up before i arrive on site
thanx for your reply

 

[Skogsgurra]

OK. Good precautionary measure.

I have had some of these just dying. Was something in the PSU. But they never healed themselves.

Gunnar Englund

http://www.gke.org

 

[grommit9999]

Yep i think youre right.
Im taking a 590P (newer replacement) with me just in case.
Great forum btw.

Dave