Christian_RR
Aerospace
- Jul 9, 2024
- 3
I'm working in NX 1953 and trying to export the ANT and Mass Properties, as I need combined information from both. I am aware than NX is unable to export these as a single document. However, when exporting the assembly navigator and the mass properties, I get a large difference in the number of items exported (~9000 from ANT vs. ~12,000 from Mass Properties). Has anyone run into this issue before? I understand that when exporting the ANT, it is exported just as displayed in NX. What is being exported when exporting from the Mass properties tab? Is it not the mass properties of each component in the ANT?