Ozcar
Aerospace
- Mar 17, 2023
- 7
Hi everybody,
we are still starting up, so we have some freedom in choosing all our set-ups. For the set-up of the drawing titleblock I was requested to include the mass of the part / assembly decribed in the drawing. The idea is that it can serve as a quick qualitycheck, but without a tolerance it will probably cause a lot of headaches.
Can anybody point me in the right direction on how to select a sensible mass tolerance? Are there any standards for this? Is this even a thing that is done commonly or ever? Any thoughts on this would be greatly appreciated.
we are still starting up, so we have some freedom in choosing all our set-ups. For the set-up of the drawing titleblock I was requested to include the mass of the part / assembly decribed in the drawing. The idea is that it can serve as a quick qualitycheck, but without a tolerance it will probably cause a lot of headaches.
Can anybody point me in the right direction on how to select a sensible mass tolerance? Are there any standards for this? Is this even a thing that is done commonly or ever? Any thoughts on this would be greatly appreciated.