Extracted edges problem 1

[TechnicalConsultant]

Hi all,

When I add a view in drafting extracted edges are turned off. When I went to change the customer default setting they are set as being associative.

I want them to be set at associative but the actual setting doesn't seem to reflect the default setting.

Any ideas much appreciated.

 

[cowski]

If you are using a template file (aka seed part), then that setting was/is inherited from the template part and not the customer defaults. Change the setting in your template file and any new parts created from that template should reflect the change. You will also have to change the setting in your current file so that future views that are created will reflect the desired setting.

 

[TechnicalConsultant]

THANK YOU!