Eduardo_Mattos
Mechanical
- Nov 17, 2023
- 1
Hi,
I appreciate if I can have some help to make my NX12 work properly with Excel. I´m stucked two days trying to fix it.
The Siemens NX12 version and now Excel 2010 (32 bits)are installed. I was trying to model a part family when the following message prompted:"failed to set Excel running".
The following actions were done/checked:
1. Availability of the add in in the Excel (option\add in). It is listed there but when I checkmark it and press "ok" buttom, appears a message from windwons pointing opening prevention . I turned off the protection options but it didn´t solved;
2. Excel 2010 - 32 bits installation, following some advices found in the internet, warning about this for NX12 version;
3. Add in "ug.xla", proper directory place (c:\programfiles\Siemens\NX12.0\UGII).
Thanks in advance!
I appreciate if I can have some help to make my NX12 work properly with Excel. I´m stucked two days trying to fix it.
The Siemens NX12 version and now Excel 2010 (32 bits)are installed. I was trying to model a part family when the following message prompted:"failed to set Excel running".
The following actions were done/checked:
1. Availability of the add in in the Excel (option\add in). It is listed there but when I checkmark it and press "ok" buttom, appears a message from windwons pointing opening prevention . I turned off the protection options but it didn´t solved;
2. Excel 2010 - 32 bits installation, following some advices found in the internet, warning about this for NX12 version;
3. Add in "ug.xla", proper directory place (c:\programfiles\Siemens\NX12.0\UGII).
Thanks in advance!