Family molds in NX5

[atmbob]

Is it possible to add the second part of a family mold after the project has gone through the initialization and subsequent steps, yielded a cavity and core set, and been saved?

Bob

 

[NXMold]

I'm sure by now you've found an answer or work-around, but I'll chime in anyway.

You can add additional Product nodes to the assembly at any time by clicking Initialize Project. These additional product sub-assemblies will have their own workpiece, core, cavity, etc. If you are combining multiple parts into a single insert or solid plate, link the core and cavity bodies into that component. NX6 and later provides a combined model for this purpose, but I have to admit not using it yet.

NX 7.0.1.7 MoldWizard

 

[atmbob]

Yes, that's the solution that I found. I baulked at the "Initialize Project" icon and was afraid I'd have to start anew. But that's not the case.
Thanks for the reply. It gives the method for others atleast.

Bob