Fanuc Memory card for RJ2 controller 1

[roland7800]

Hello
I’m looking for a memory card for Fanuc RJ2 controller to do backups and change data between robot and Pc.
Does any body know how can i sell this card?
Thanks !
roland

 

[tygerdawg]

Fanuc can sell you their DOS-based program called "KFLOPPY". It is a floppy drive emulator. Connect your PC to RJ2 via RS232 cable and transfer files.

TygerDawg

 

[roland7800]

Thanks TygerDawg
I work with the "Kfloppy", the problem is the data save takes a long time, i have 82 old robots to program. Normal PCMCIA card works only up to RJ3, yes i can by the special PCMCIA card by fanuc, but that cost me 400$.
greet from Austria
roland

 

[chriskei]

I have an RJ Controller. How do I start the process to load SpoTTool onto the RJ controller. I have the KFLoppy software and SpotTool image but no documentation on how the start the transfer process. It is different from the menus given for a RJ2 controller.

Thanks