Sep 1, 2004 #1 dean01 Aerospace Sep 1, 2004 2 Is it possible to view a V4 model containing FD&T information in V5? If so How?
Sep 1, 2004 #2 tkchiu Industrial Mar 27, 2001 42 Hi dean01, It's me again!! Fairly confident that it can be done ... 1. File + New a CATProduct 2. Insert the V4 model into it 3. Move your cursor on top of the GD&T set 4. MB3 + Annotation set switch on/switch off ... 5. You can of course further migrate them by Copy the GD&T set 6. Then paste it under the new CATProduct Cheers. Kennis Tang. Upvote 0 Downvote
Hi dean01, It's me again!! Fairly confident that it can be done ... 1. File + New a CATProduct 2. Insert the V4 model into it 3. Move your cursor on top of the GD&T set 4. MB3 + Annotation set switch on/switch off ... 5. You can of course further migrate them by Copy the GD&T set 6. Then paste it under the new CATProduct Cheers. Kennis Tang.
Sep 2, 2004 Thread starter #3 dean01 Aerospace Sep 1, 2004 2 Thanks for the advice... I have tried your recomendations, unfortunately without success... when I use MB3 I do not get the option to swith annotation on or of. Upvote 0 Downvote
Thanks for the advice... I have tried your recomendations, unfortunately without success... when I use MB3 I do not get the option to swith annotation on or of.
Sep 6, 2004 #4 tkchiu Industrial Mar 27, 2001 42 Hi dean01, Can't ?!?! No need to say that you have FT&A license, haven't you? Try this one 1) View + Commands List 2) Look for the command "Annotation set switch on/switch off" 3) double click it 4) you should have it ... Cheers. Kennis Tang. Upvote 0 Downvote
Hi dean01, Can't ?!?! No need to say that you have FT&A license, haven't you? Try this one 1) View + Commands List 2) Look for the command "Annotation set switch on/switch off" 3) double click it 4) you should have it ... Cheers. Kennis Tang.
