scotland6
Mechanical
- Feb 6, 2001
- 20
Hi,
I am creating a FE model of a heat source cooled using a pelter mounted to a copper block then to a heatsink. I am wondering on how to represent the characteristics of the peltier in steady state then a transient model. I am assuming the hot side of the peltier is at 50°C with a deltaT of 60°C. How do I model this in solidworks simulation? Small square is heat source.
Regards
I am creating a FE model of a heat source cooled using a pelter mounted to a copper block then to a heatsink. I am wondering on how to represent the characteristics of the peltier in steady state then a transient model. I am assuming the hot side of the peltier is at 50°C with a deltaT of 60°C. How do I model this in solidworks simulation? Small square is heat source.
Regards
