FEA Simulation

[harrytos23]

Good Day,

I am designing a fixture where we can put a strap and pull it. I am wondering if there's any other way to do the FEA for this fixture.

I designed two I beams parallel together while the cylinder rod is welded to one I beam and one have clearance so we can strap the webbing. I run the simulation and the predicted load but Solidworks FEA does not account the other I beam as stopper for the cylinder. I designed this to distribute the load to each I beam instead of one I beam taking all the stress. I will attach the starting photo and photo after the simulation.

 

[rb1957]

do you have "contact" set up ?

 

[BEMPE16524]

you need to set the contact between the rod and the I-beam properly.

 

[harrytos23]

you need to set the contact between the rod and the I-beam properly.

Thank you! I was able to make it work. Thanks again!

 

[Joyaloorg]

This information was useful for me as well
how nice it is that you can find an answer to your question without even voicing it