FEMAP display of loads & constraints refresh 1

[LeonardoBer]

Hello everyone.

For some reason FEMAP doesnt want to refresh its display of loads & constraints. When i activate any loads/constraints set, the display is stuck on one particular set. Even if I create a new load set, I am not able to see it because the model only displays that one load set. I am only having this problem with one model, other models seem to update the display just fine. Anyone else have had this issue?

 

[BlasMolero]

Dear Leonardo,
Not experienced this problem before, which version of FEMAP are you using?.
Best regards,
Blas.

~~~~~~~~~~~~~~~~~~~~~~
Blas Molero Hidalgo
Ingeniero Industrial
Director

IBERISA
48004 BILBAO (SPAIN)
WEB:

http://www.iberisa.com

Blog de FEMAP & NX Nastran:

http://iberisa.wordpress.com/

 

[ThomasH]

Hi

Could it be that you under "Visibility"-"Load/Constraint" have selected a specific Load and Constraint Set, instead of the Active Set?

I think that I have done that by mistake at some time.

Best regards

Thomas

 

[Sparweb]

Yes, that was one of my frequent "rookie" mistakes.
With FEMAP, I was still making those kinds of mistakes after 2 years of using it...

http://www.sparweb.ca

 

[LeonardoBer]

ThomasH, that was absolutely it! I didnt even know about this feature in femap.

I had been working with the model all this time since the original post, without being able to see the loads that I am applying- what a pain. Thanks alot.

 

[rb1957]

surely ThomasH's post is worth an LPS ?

another day in paradise, or is paradise one day closer ?

 

[LeonardoBer]

Sorry but what is an LPS?

 

[rb1957]

Little Purple Star, beside "great post" ... the post exactly answered your question ... that deserves recognition.

another day in paradise, or is paradise one day closer ?