Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations KootK on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FHWA Hydraulic Toolbox Stream Section Import 1

Status
Not open for further replies.

AJB1262

Civil/Environmental
Jan 3, 2017
18
is there a way to enter a stream cross section into the channel analysis without manually defining in the cross section menu?
Import of TW file is referenced but no documentation is provided on HY 8 TW file format.
Any information is appreciated.
 
Replies continue below

Recommended for you

The format of an HY-8 TW file appears to be comma delimited ASCII with the following fields (no header):
Station, Elevation, Manning's n
 
****UPDATE***
I did try creating a TW file based on the above mentioned format but still no results.
What I did find was if I cut and pasted from an excel file with the three fields, HY toolbox accepted the data.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor