Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Fill Pattern help

Status
Not open for further replies.

wojtekthebear

Mechanical
May 23, 2014
1
Hey guys! I need a small bit of help here so I don't go insane and start smashing stuff.

I am currently modeling a small project of mine and it utilizes a repetitive pattern of cuts along a face. However, I cannot for the life of me figure out how to 1) limit the number of repetitions across the space or 2) define the spacing of the pattern from either end of the object. Is there something that I am missing or do I have to brute force everything?
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor