sldwrksrobotics
Mechanical
Has anyone had success trying to model a weldment (as an assembly) inserting an assembly feature of a fillet weld. Then running simulation to look at the results including the stress in the welds. Is this even possible.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Fillet weld analysis
- Thread starter sldwrksrobotics
- Start date
- Status
yes, it works. The feature in solidworks inserts a fillet bead as a separate part. You then need to mate it appropriately and apply bonding etc for contacts.
however, there is another connection avaliable in simulation known as 'edge weld' and 'spot weld'. i do not yet know how these work.
however, there is another connection avaliable in simulation known as 'edge weld' and 'spot weld'. i do not yet know how these work.
rumandcola
Mechanical
- Apr 6, 2009
- 47
- 0
- 0
Not anymore, they've removed this in SolidWorks 2012. You only get a callout but it no longer models the weld bead.
- Status
Similar threads
- Locked
- Question
