Find and select all surface cones (primitive) 1

[DanielMadureira]

Question: Is there a way to find and select all true cones in a catpart?

When you use the "measure item" tool, and you hover your cursor over a given entity, it will show the type of geometry:

. An "x" for a point
. A rectangle for a plane
. A curved line for splines
. A mini cone, if the surface is a primitive
Etc


Is there a way of detecting the entity type, and select it - via VBA OR CatScript?

Thanks

 

[DanielMadureira]

Not only i found it, but i made a userForm if anyone wants it.

 

[itsmyjob]

thanks for sharing result

Eric N.
indocti discant et ament meminisse periti ​