Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Select surface in sidewall/thickness

Thread starter rookiezzz
Start date Dec 5, 2023

Status: Not open for further replies.

Dec 5, 2023

rookiezzz

Structural

Hello all:

I'm looking for a way to select the surface in sidewall/thickness by macro. Then I can run my code based on that like measure thickness or extend the boundary of part as I wish. I'm working on metal forming part which may contain one or serval thickness. Sample is attached. Do anybody know about this？