Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Finding features in a drawing NXOPEN

Thread starter pcalonzi2
Start date Nov 10, 2013

Status: Not open for further replies.

Nov 10, 2013

pcalonzi2

Mechanical

Hi Everyone,

I was wondering if anyone could provide some documentation for the UF function: AskFaceOfSil

I am trying to connect the dots between an extracted edge on a master model drawing and determine the face that created the edge. My end goal is to pick an edge of a Hole created as a hole feature and find the original edges, faces, or feature that generated the hole on the drawing sheet.

Any suggestion?

Thank you,
-Pat

Thank you,
-Pat