Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

First angle & Third angle 1

Status
Not open for further replies.
meceugen

meceugen

Mechanical
Dec 3, 2007
8
Hi,
I can't switch these option, although I had changed the settings in Tools-Options nothing happened. It's a SW 2008.
Can anyone advise, please?
Thanks.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
The angle projection can be changed in the drawing document.

Open a drawing file
RMB on the sheet
Select Properties
Select the projection required
Select OK
Save As new template

[cheers]
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

joshF
  • Locked
  • Question
Improve my macro for sorting a SW Bill of material so Sub-assemblies come first.
Replies
1
Views
1K
ROHITKN
ROHITKN
Rodger Furey
  • Locked
  • Question
Solidworks Configurations - file size & non-dimensional differences
Replies
2
Views
444
SSCon
SSCon
jassco
  • Locked
  • Question
Unable to use dual dimension in feature control frames (GD&T) in Solidworks 2023
Replies
5
Views
1K
3DDave
3DDave
Platypusimon
  • Locked
  • Question
calculating the mass & volume of section of a part/assembly model in solidworks
Replies
10
Views
964
jassco
jassco
borsht
  • Locked
  • Question
Tolerancing grayed out on drawing when adding & modifying hole dimensions
Replies
1
Views
784
SBaugh
SBaugh

Part and Inventory Search

Sponsor

Back
Top Bottom