Fixed & Sliding Saddles on Pressure Vessels 4

[izamil]

We are currently designing a horizontal pressure vessel 20’ diameter X 191’ long. We are designing this vessel to rest on two saddle supports. A fixed, and a sliding saddle.

On the sliding saddle side, we are contemplating if we are to allow for slotted holes for thermal expansion or should we just have the sliding saddle rest on the concrete plinth without any guiding anchors?

I would appreciate your assistance,

 

[LSThill]

izamil (Mechanical)

PAST SEMINAR NOTEBOOKS AVAILABLE

Available at $75.00 per set are:
1994 ASME B31.3 Piping Code Seminar
2001 Piping Design & Pipe Stress Analysis Seminar
2001 Pressure Vessel Seminar - Sec. VIII - Div. 1, 2, 3
Order your seminar notebook from KATHY SMITH at 713-523-4565 or FAX 713-523-6767
and send your check along with your request for the set(s) that you need to
South Texas Section ASME at P.O. Box 25045, Houston, Texas 77265.

 

[izamil]

Thank you very much Ishill

You have been of great help.

 

[Shahin71]

lsthill (Mechanical)
Regarding the seminars notes is there any bank details so we can send money by DD or TT instead of mail.mail takes long time.

shahin71

 

[LSThill]

izamil (Mechanical)and Shahin71 (Chemical)

Boiler Pressure Vessel prep course.
The best source of information concerning the course is our website at

http://ccs.goivytech.net/boiler_pressure/index.html

.

Lea Anne Crooks
Executive Director
Corporate and Community Services
Phone: 812-298-2367
Fax: 812-877-1184

 

[LSThill]

izamil (Mechanical)and Shahin71 (Chemical)

please check this

http://www.thill.biz

Leonard