Fixing-together BOM chart and isometric view?

[cemunal2000]

Hello
In 2d drafting module is it possible to Fix-together the automacially generated Bill Of aterial BOM chart and its isometric view?
so that when I move the View, i want BOM-table to move as well.
How can i Fix or attach them together?

 

[jackk]

Cut & Paste the BOM into the isometric view.

The next time you create a new table, make sure the isometric view is active.

 

[cemunal2000]

Actually i need another solution than cut/copy & paste. Do you have another solution?

 

[jackk]

Activate the isometric view, and create a new BOM.

 

[cemunal2000]

Suppose isometric view's link is broken and i don't have the original 3D Catproduct. So i can't create anY BOM again. I have only BROKEN 2d and i want to attach its BOM table to the available broken view.
Is it possible to attach them somehow?

 

[Daniel Popa]

Copy/cut-Paste could break the links of the BOM with the model but since you do not have the it anymore and the drawing is "dead" then there will be no problem in doing this. Unfortunately you can not set a positional link between a table and a view.
Good luck.

 

[itsmyjob]

Create a new view and make assembly view in it, make the BOM in that view.

activate your isolated view and create a left or right view from it, the position will be dependant of the isolated view.

Then copy/paste the BOM to the left/right view created previously.

delete the view made for the assembly.

Eric N.
indocti discant et ament meminisse periti ​