Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flat head with multiple holes - VIII Div.2 calculations

Status
Not open for further replies.

timsch

Mechanical
Oct 27, 2009
181
I am accustomed to calculating the thickness of integral flat heads with multiple holes bored through them using ASME BPVC SECTION VIII, DIV.1, but now have been tasked with doing the same with Div.2. I am only able to perform design by rule analyses in part 4 at this time. I don't see in part 4 where multiple holes in an integral flat head are addressed. The closest I find is a central large opening in a flat head.

Is this a component that must be designed by analysis in part 5 of Div.2?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor