Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flat pattern a tube

Status
Not open for further replies.

aussiedesigner

Mechanical
Feb 11, 2013
17
Hello again,

Been looking for a way in NX8.5 to flat pattern a tube thats been extruded along a studio spline. IE: Radiator hose

Objective is we want to create a manufacturing drawing of the straight hose.

Any suggestions?

Thanks...

Aussiedesigner
 
Replies continue below

Recommended for you

You don't actually mean to 'flatten' the hose but to mearly make it 'straight', correct? If so, I would go with Deformable Component, where in the manufacturing drawing it's referencing a straight line while in the assembly it's referencing a spline.

John R. Baker, P.E.
Product 'Evangelist'
Product Engineering Software
Siemens PLM Software Inc.
Industry Sector
Cypress, CA
Siemens PLM:
UG/NX Museum:

To an Engineer, the glass is twice as big as it needs to be.
 
Thanks John...yes meant to say make it straight. Will try Deformable Component.
 
When I had to do some hose drawings, I modelled the hose in the as-installed shape (using curves for the centre line then putting a tube around it), then made an associative measurement in the model. I then jumped into the drawing and modelled a straight length of tube with the length, ID and OD parameters on the sketch linked back to the model file, so that once the model updated, the drawing would too. Bit of a funny work-around, but at least I knew the length's matched up. I've not worked with Deformable Components, so I'm not sure whether that's easier.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor