Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Flexible Printed Circuit Board : Loft Transition: Unable to select bridge curves

Thread starter CAD Application Support
Start date Feb 13, 2020

Status: Not open for further replies.

Feb 13, 2020

CAD Application Support

Mechanical

Hi All,

Iam having trouble to select bridge curves when trying to build loft transition in FPCB application in NX. NX1888. Is there a reason why Siemens do not allow this selection? I have to break the spline curve to small bits of curves by using simplified curve to get the loft transition to work.