Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations GregLocock on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

FLOTHERM error. Can U make anything of it?

Thread starter Tunalover
Start date Dec 4, 2002

Status: Not open for further replies.

Dec 4, 2002

Tunalover

Mechanical

I installed my Flotherm CFD software (V2.1) and am getting an error message on startup. Can you make anything of it? Should it be cause for alarm?

"ERROR E/01025-Unable to access Solution Data <possible file permission problem or file-system is full?>"

Why would the code look for “Solution Data” when I hadn’t even specified a project (or built a project for that matter)? This error message came up immediately when I started my first session. It comes up whenever I open the software.

Thanks for your help!

Tunalover