Floworks Display Problem.

[martini44]

I'm doing an internal flow analysis in floworks.Everything works fine.I get the results correct. But when i'm displaying results i can't see contours or any trajectories.Just the model stands there itself.
And this happens in all results such as cut plot, flow trajectories, surface plot.I can only see trajectories or contours in animation mode.What am i doing wrong?Help Plz..

 

[martini44]

By the way i'm using Solidworks 2006 and Floworks 2006..

 

[GRF]

check to make usre your graphics card driver is approved by SW.

 

[Brodie79]

Floworks seems particularity sensitive to not having the correct graphics card more that any other part of application I would check you card is certified by SW first as GRF suggested.