Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

fluid mixing inside a water block

Status
Not open for further replies.

MisterE2

Mechanical
May 16, 2011
34
So, I've been messing around with a hybrid water block-heat pipe design for a few months. I'm just crossing out possibilites for fun with a sla printer and a miniscule budget. Anyway, I want to experiment with adding more mixing to some prototypes, and I have no idea what a submersible motor looks like that would fit inside the space between the heat pipes and fins I want to use. Any ideas?
 
Replies continue below

Recommended for you

Drawing? Sketch? Dimensions?

Remember - More details = better answers
Also: If you get a response it's polite to respond to it.
 
eh, actually nevermind, nothing inexpensive exists that i can shove into a waterblock without everything being exposed to anodic/cathodic reactions from the copper, back to using pumps
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor