Flushing notes on engineering drawing

[valmeidan]

I am looking for notes on flushing. I designed a stainless steel manifold out of square mechanical tubing as seen in the attached pic. No my question is what note should I put in the drawing to ensure the assembly is flushed with clean water. I am not sure how to put it in technical terms. I have already added deburring notes etc, but not sure if I should just type in "flush with distilled water" or something that follows a standard if one exists????

 

[MintJulep]

You should read thread404-358596

 

[dhengr]

Valmeidan
I think the note should read.... “Flush after using, and put the damn seat down.” Signed, The Wifey, or Girlfriend. If she’s (they’re) happy life is easier for everyone.

 

[rb1957]

is this medical ? i'd've thought we'd normally degrease things after ass'y. how about cleaning with air ?

if you're doing the next stage ass'y in-house, why not clean the part then ?

Quando Omni Flunkus Moritati