Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Force of installation

Status
Not open for further replies.
eichman

eichman

Automotive
Apr 29, 2010
8
Hello,

Is there a formula to calculate the force (Push or Pull) required to install a Pin which has O-rings and back-up rings on it into a Box?

Thank you for your suggestions
 
Status
Not open for further replies.

Similar threads

BasakAbhishek
  • Question
Estimation of torque in stuffing box of pumps
Replies
5
Views
2K
BasakAbhishek
BasakAbhishek
BasakAbhishek
  • Question
Sealing of gases by lip type seal
Replies
6
Views
2K
dgeesaman
dgeesaman
moon161
  • Question
Dry gas instead of liquid for leak test in pump w/ mech seal.
Replies
4
Views
2K
A8yssUK
A8yssUK
MechyMarco
  • Locked
  • Question
PEEK Piston Cap Instead of PTFE?
Replies
0
Views
64
MechyMarco
MechyMarco
Cenzoto
  • Locked
  • Question
Identification of this type of O-ring retention system using U-bolt pin 1
Replies
6
Views
136
Cenzoto
Cenzoto

Part and Inventory Search

Sponsor

Back
Top Bottom