Force Pre-NX85 View Representation at view creation ?

[daluigi]

Any way to force Pre-NX85 View Representation at drafting view creation ?

NX Version: 85

 

[Toost]

I have no idea on how but i am very curious on why you want to do this.

- Why ?

Regards,
Tomas

 

[daluigi]

While exporting to dwg/dxf, NX ignores the detail views boundaries if views have been created/represented as "Exact" - the result is lines all over the exported drawing...
An IR is still under investigation for that until 2014 so the solution so far is to go back to Pre-NX85 view representation which do not have the issue mentioned above.

 

[NutAce]

There are numerous reasons NOT to use the exact type view for Sections... (in NX8.5)
One of those is that we experienced that you cannot hide assembly components in such a view

Ronald van den Broek
Senior Application Engineer
Winterthur Gas & Diesel Ltd
NX9 / TC10.1.2
HPZ420 Intel(R) Xeon(R) CPU E5-1620 0 @ 3.60GHz, 32 Gb Win7 64B
Nvidea Quadro4000 2048MB DDR5

HP Zbook15
Intel(R) Core(TM) i7-4800MQ
CPU @ 2.70 GHz Win7 64b
Nvidia K1100M 2048 MB DDR5

 

[cowski]

Any way to force Pre-NX85 View Representation at drafting view creation ?

Yes, in the customer defaults (Drafting -> view -> general) turn on the "enable exact (pre-NX 8.5) views" option and pick the desired representation. If you have drafting template files set up, be sure the option is set in the templates as well (Preferences -> view -> general).

www.nxjournaling.com