Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Forming of Thermomechanical Beams - How to select Cold or Hot?

Thread starter lgracio
Start date Sep 24, 2014

Status: Not open for further replies.

Sep 24, 2014

lgracio

Mechanical

Hi,

Someone to know how to find a solution to perform bending/forming on H-BEAM HEA360 with 5881mm length and bend radius of 16161mm? How can I select the forming process? Cold or Hot? Knowing that the material is S355J2+M.

Thanks for any support if available.

Luís Grácio
Mechanical Engineer (Engineering Solutions)
Portugal-Setúbal