Aug 6, 2008 #1 Ork1 Mining Aug 5, 2008 26 0 0 US I was wondering if anyone has a formula for figuring out the length of a conveyor belt rolled up on a spool.
I was wondering if anyone has a formula for figuring out the length of a conveyor belt rolled up on a spool.
Aug 11, 2008 #2 minerk Mechanical Feb 2, 2004 77 0 0 US Here's one I found, I can't tell you if it works or not... Belt length in feet = A x number of coils x 0.131 A = Diameter of coil in inches + Diameter of coil hole in inches Upvote 0 Downvote
Here's one I found, I can't tell you if it works or not... Belt length in feet = A x number of coils x 0.131 A = Diameter of coil in inches + Diameter of coil hole in inches
Aug 14, 2008 #3 Compositepro Chemical Oct 22, 2003 7,721 0 36 US L = (3.14/2T)(od-id) where T is thickness of each layer L is length of roll od = outside diameter id = inside diameter Use consistent units and conversion factors. Upvote 0 Downvote
L = (3.14/2T)(od-id) where T is thickness of each layer L is length of roll od = outside diameter id = inside diameter Use consistent units and conversion factors.
Aug 15, 2008 #4 telnique Mining Aug 13, 2008 1 0 0 LC I use this one and it works all the time. L = NS X .2618 Where L = length N = Number of turns on belt S = Measured inches between ends on roll of belt Upvote 0 Downvote
I use this one and it works all the time. L = NS X .2618 Where L = length N = Number of turns on belt S = Measured inches between ends on roll of belt