Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!

frp and solid185

Status
Not open for further replies.
RJcivileng

RJcivileng

Structural
May 16, 2012
16
0
0
TR
hi all
i am using solid185 to model frp
but how can i enter the failure criteria "tsai-wu" for this element?
what parameters should i enter.....and should i enter the failure criteria before or after i do the analyze .
thanks
 
Status
Not open for further replies.

Similar threads

IJR
  • Question
On how and where to insert command snippets inside Workbench mechanical
Replies
2
Views
31
IJR
IJR
LIAM_7
  • Locked
  • Question
ANSYS and fatigue analysis
Replies
0
Views
8
LIAM_7
LIAM_7
pmbov
  • Locked
  • Question
ANSYS Mechanical and Max Cores
Replies
0
Views
15
pmbov
pmbov
CKerr
  • Locked
  • Question
Change Integration Points and type in Mechanical
Replies
1
Views
10
centondollar
centondollar
shiraz883
  • Locked
  • Question
Nodal forces and Von-mises stress
Replies
0
Views
13
shiraz883
shiraz883
Back
Top