functionality SP5 CATIA/ENOVIA V5R9

[mje]

Hi everybody,
We worked with SP2 in Enovia DMU V5R9 (on WinNT).So, we hade big problems with functionality of command SHUTTLE in Fitting product. SP5 solved this problems, but started other huge problem: Enovia DMU with this SP5 tessalate all v4 models from our CACHE directories. This models was tessalated by V5R8 and V5R9 SP2 in past.We hade in CACHE cca. 9 GB of cgr files.We worked with very large products and this fact is for us very ugly !!! But there is another one big problem. When we tessalated any product with v4models to V5R9 SP5 and after tessalation open =>> we wait more longer (cca 10x longer) then the same product opene and tessalated from V5R9 SP2. Does anybody know about this bug and has any solution ?

 

[pepad]

mje. Send a bug report to IBM. pepad

 

[jonoheap]

I too have seen the same problem in V5R9 SP4 on AIX.
Our automotive uses have noticed a severe loss in the performance since we moved from V5R8 and ore complaining on a daily basis. We also have tested SP5 but things are no better.
We have opened a PMR with Dassault over this.