fusing codes for motor control panels 1

[plcrookie2000]

Good Morning All,
This will be my first thread or question on this site.

I need some help in codes requirements?

I am building a motor control panel with a 480v 3phase 30amp fused disconnect.
I want to know if fusing the panel and adding overload protection on the motor starters is sufficient to satisfy code?

I am in California......Thanks....

 

[jraef]

Provided you do it according to code, yes. Assuming it is a motor load, the requirements are laid out in section 430 of the NEC.

JRaef.com
Eng-Tips: Help for your job, not for your homework Read faq731-376

 

[plcrookie2000]

JRaef.com
thanks a-lot for the help...... let me go ahead and review the nec book.......