Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

GD&T question for European Drawing 2

Status
Not open for further replies.
Rooster67

Rooster67

Mechanical
Mar 27, 2006
11
CH
I am trying to establish the correct meaning of the GD&T symbols used in a dutch drawing.
I'm not sure how old the drawing is, but the GD&T symbols don't seem to follow the current ISO 1101 standard.
Can anyone help me interpret the GD&T correctly?
 
Replies continue below

Recommended for you

Sort by date Sort by votes
Wow, I didn't even notice the other surface finish callout. It is incorrectly indicated. A surface finish should be applied to a surface. If the intent is to have the finish apply to the sides of the peaks, then the symbol should be pointing directly to the surfaces, with a pointer touching them.

Powerhound, GDTP T-0419
Production Supervisor
Inventor 2008
Mastercam X2
Smartcam 11.1
SSG, U.S. Army
Taji, Iraq OIF II
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

ericscottf
  • Question
Proper GD&T for interrupted threads?
Replies
14
Views
134
ericscottf
ericscottf
Qcprick63
  • Locked
  • Question
GD&T Question
Replies
10
Views
32
Qcprick63
Qcprick63
efulm4444
  • Locked
  • Question
GD&T Question - Properly Defining a Global Tolerance
Replies
2
Views
36
drawoh
drawoh
DimaM
  • Question
GD&T: How to inspect tertiary datum feature position tolerances?
Replies
7
Views
84
Burunduk
Burunduk
MattEdwards
  • Locked
  • Question
GD&T for hinge holes
Replies
7
Views
46
Burunduk
Burunduk

Part and Inventory Search

Sponsor

Back
Top