Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Gear in Catia 1
- Thread starter mrr1671
- Start date
![[bandito]](/data/assets/smilies/bandito.gif "[bandito] [bandito]")
Configurator
New member
Circular "Pad" feature.
Use the "Pocket" feature to create one tooth.
Use the "Circular Pattern" feature on the tooth pocket.
Use the "Pocket" feature to create one tooth.
Use the "Circular Pattern" feature on the tooth pocket.
Configurator
New member
There are a bunch of ways to make things in CATIA.
Some people might say: make a disk and add teeth to it.
That would work too, but I don't like it. I'll often try to model things as they'll be built (though this isn't always best for CATIA).
How would I machine a gear? I'd turn a disk, diameter equal to my design tooth diameter, then I'd cut out the teeth. So that's what I'll do in CATIA.
Some people might say: make a disk and add teeth to it.
That would work too, but I don't like it. I'll often try to model things as they'll be built (though this isn't always best for CATIA).
How would I machine a gear? I'd turn a disk, diameter equal to my design tooth diameter, then I'd cut out the teeth. So that's what I'll do in CATIA.
-
1
- #4
- Thread starter
- #6
![[bigsmile]](/data/assets/smilies/bigsmile.gif "[bigsmile] [bigsmile]")
- Status
Similar threads