Geopak 3-D Surfacing

[namdac]

I have been trying to create a surface in 3-D so that I can do a drive-thru. When I interpolate between sections it keeps telling me I have color mismatch and when they finally do interpolated I have twisted surfaces and warped surfaces in relationship to my design. any ides?

 

[RAWeber]

Try this again over on the Geopak forum, you might g
et better response... Robert Weber, EI
Maurer-Stutz, Inc

http://www.maurerstutzinc.com

"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."

 

[RAWeber]

Try this again over on the Geopak forum, you might get better response... Robert Weber, EI
Maurer-Stutz, Inc

http://www.maurerstutzinc.com

"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."