Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Glass machining

Status
Not open for further replies.

kzt

Aerospace
Jul 11, 2019
1
What is the optimal way to create a chamfer or radius on the edge of a fused quartz (glass) part - ie. are there special machines that just do this? Tried using a CNC machine but not only did the edge have chipping all around but it also took a long time (8000rpm and used diamond tooling). Not sure I hit the right sfm...

Appreciate any helpful responses!

Thank you!
 
Replies continue below

Recommended for you

Grinding, typically wet grinding. Slow feeds, lots of coolant.
 
I've seen 5-axis waterjet do this with abrasive particles. Surface finish is semi-rough like sandpaper though.

TygerDawg
Blue Technik LLC
Virtuoso Robotics Engineering
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor