Graphics issue

[SiW979]

Hello People

Some of our users are experiencing graphics issues (see attached image) All the usual suspects don't seem to work refresh, regenerate work etc) however it fixes itself if you fit the part to view, but then the issue comes back as soon as you start to move or rotate the part. Any help would be greatly appreciated.


Best regards

Simon (NX4.0.4.2 MP9 - TCEng 9.1.3.6.c)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...

 

[MSPBenson]

Looks as though you are displaying the faceted model over the top of the true geometry?
Just a guess.

Mark Benson
Aerodynamic Model Designer

To a Designer, the glass was right on CAD.

 

[ewh]

Yes, it looks like there are more than one entities sharing the same model space.

"Good to know you got shoes to wear when you find the floor." - [small]Robert Hunter[/small]

 

[cowski]

Looks like a problem from last year popping up again?
thread561-217467

 

[JohnRBaker]

Yes, I could have sworn that we had covered this before because I could remember showing an example like this to one of our developers in the graphics group and she suggested that is was possible the view extents needed to be reset.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[uwam2ie]

... looks like activated product outline

 

[hudson888]

Simon,

I asked you last time and perhaps more specifically what if any hardware differences exist between users who do and do not have this problem? What hardware and operating system have you on the workstations where it is most commonly happening?

Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum