Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Grinding PTFE Coated 304 SS

Status
Not open for further replies.
FTLisa

FTLisa

Mechanical
Dec 28, 2005
1
We flate grind the ends of PTFE coated SS wire that has been coiled into a heliz. We always have problems with strings of the PTFE hanging from the ground end. Has anyone had a simlar problem they have solved?
 
Status
Not open for further replies.

Similar threads

Tarun Tanwar
  • Locked
  • Question
How to flatten ss 304 sheet after perforation or punching?
Replies
6
Views
488
EdStainless
EdStainless
SwimTsunami2
  • Locked
  • Question
ISO coated spring maker 2
Replies
5
Views
113
EdStainless
EdStainless
RanaAq
  • Locked
  • Question
Centreless grinding of end flat shaft
Replies
0
Views
101
RanaAq
RanaAq
Tarun Tanwar
  • Locked
  • Question
Can we get flat SS 316L in full hard sheet form?
Replies
1
Views
302
EdStainless
EdStainless
Ashwani Kumar
  • Locked
  • Question
Requirement of Diaphragm seal's PTFE & PFA coating Procedure
Replies
0
Views
51
Ashwani Kumar
Ashwani Kumar

Part and Inventory Search

Sponsor

Back
Top Bottom