Jun 19, 2001 #1 wdornfeld Mechanical Mar 26, 2001 16 Has anyone seen rules of thumb or calculations for designing press fits for putting a knurled metal post into a smooth metal hole? Thanks
Has anyone seen rules of thumb or calculations for designing press fits for putting a knurled metal post into a smooth metal hole? Thanks
Jun 19, 2001 #2 apropos Mechanical Mar 22, 1999 9 I would start by checking your manufacturer. Below is one possibility. Good luck. http://www.driv-lok.com/knurledp.htm Upvote 0 Downvote
I would start by checking your manufacturer. Below is one possibility. Good luck. http://www.driv-lok.com/knurledp.htm
