HELIX SPIRAL SHEETMETAL 1

[DMIYM]

Ok i"m new to the site so bare iwth me. Need a Helix spiral sheet metal .1875x2" that looks like the pic. I have tried a number of ways and failed. In this thread thread559-160215 they say to check out a web site but i can not get ot it it keeps saying operation timed out? But someone els goes on to say "that's a good point useing surfaces"? Can someone fill in the blanks for me and spell out what they are talking about. Or tell me a good way of doing it?

Thanks!
Daniel

 

[Gupta65]

Check this

https://forum.solidworks.com/message/148510#148510

Deepak Gupta
SW2009 SP4.1
SW2007 SP5.0
MathCAD 14.0

 

[DMIYM]

Holy f#$%ing s!#t thanks Gupta65 you saved my donkey

 

[shanky1023]

I need to have a HELICAL rotor and a stator.. But the catch is i need the STATOR to have twice the pitch length but same minor diameter as the rotor... i am just unable to get a helical shape with two starts to it. Could anyone please help me out in this..
I have a picture attached to help better visualisation

 

[Eltron]

As a matter of forum etiquette, you should start your own thread.

Dan

http://www.eltronresearch.com

Dan's Blog

 

[shanky1023]

sorry did not know that Dan.. i am new.. will keep that in mind