Albertdorian
Civil/Environmental
- Mar 23, 2017
- 9
Hello everyone,
I am installing a temporary Altitude valve to cut off flow to a reservoir once this reaches a water level.
My question is if the altitude valve is not at the same elevation as the sensing line, would there be any issue?
My sensing point is below the elevation of the altitude valve just as shown in the attachment
Thanks in advance
I am installing a temporary Altitude valve to cut off flow to a reservoir once this reaches a water level.
My question is if the altitude valve is not at the same elevation as the sensing line, would there be any issue?
My sensing point is below the elevation of the altitude valve just as shown in the attachment
Thanks in advance